How to use the E315PS controller for bend correction on your press brake?

Enter the basic bending data. Use a small test piece for bending. Bending length: 35 mm. Bending angle: 90°. Back gauge size: 20 mm. Press the Run key. Start bending. Measured angle: 89°. The bending angle just achieved was 89°.

Press the Stop key. You can correct it directly here. Now we need to increase by 1°. Enter 1°. Press the Run key again. The Y-axis position will adjust.

Perform the second bend after correction. Measure again—the angle is 90°. This is the correction of the bending angle. Next, we’ll introduce the correction of bend dimensions. For example, if the inner dimension of the bend plus the sheet thickness.

Should result in a bending size of around 21.2 mm. If it is too large or too small. Press the Stop key. Enter the error value in the correction field. If the size is 0.5 mm too small. Enter 0.5 mm. Then you will get 20.5 mm. If the size is 0.5 mm too large. Enter -0.5 mm. Press the Run key. Then you will get 19.5 mm. This is the correction of bend dimensions.

For a complete overview of our machine specifications, feel free to download our brochures. If you have any further questions or require assistance, please don't hesitate to contact us.